Rheem RA1460AJ1NA — Air Conditioner - Rheem Classic Series RA14

Quick maintenance guide

Own this appliance? Track it free in HomeBase

Quick Specs

Model Number	RA1460AJ1NA
Tonnage	5.0 tons
SEER Rating	14.00
EER Rating	11.70
Refrigerant	R-410A
Compressor Type	Scroll
Operating Voltage	208/230 volts single-phase 60 Hz
Maximum Overcurrent Protection	50 amps
Minimum Circuit Ampacity	32 amps
Compressor Rated Load Amps	23.7 amps
Compressor Locked Rotor Amps	152.5 amps
Outdoor Coil Net Face Area	21.5 sq in
Outdoor Coil Number of Rows	1
Outdoor Coil Fins per Inch	22
Outdoor Fan Diameter	26 inches
Outdoor Fan Number of Blades	3
Outdoor Fan Motor	1/5 hp
Outdoor Fan CFM	4139 CFM
Outdoor Fan RPM	850
Outdoor Fan Motor Watts	254 watts
Operating Weight	240 lbs
Shipping Weight	247 lbs
Height	35 inches
Length	35.75 inches
Width	35.75 inches
Liquid Line OD	3/8 inches
Suction Line OD	7/8 inches
Refrigerant Charge	162 oz
Sound Power Level	75.0 dBA
Cooling Capacity	57000 BTU/H
Low Ambient Capability	Down to 0°F with optional kit
Long Line Capability	Up to 250 feet total equivalent length

Maintenance Schedule

Task	How Often	Difficulty	Est. Time
Coil cleaning	Annually or as needed to maintain performance	Medium	Variable
Check and clean louver panels	Seasonally	Easy	15-30 minutes
Inspect refrigerant lines for leaks	Seasonally	Medium	30 minutes
Verify all fasteners are secure	Annually	Easy	15 minutes
Check outdoor fan operation	Seasonally	Easy	10 minutes
Inspect compressor and connections	Annually	Medium	30 minutes
Verify control box connections	Annually	Medium	20 minutes

Filters & Parts

Filter Drier

Part #Field installed - part number not specified in manual

Compressor Crankcase Heater

Part #44-17402-45

Low Ambient Control Kit

Part #RXAD-A08

Compressor Sound Cover

Part #68-23427-25

Compressor Hard Start Kit

Part #SK-A1

Compressor Time Delay

Part #RXMD-B01

Low Pressure Control

Part #RXAC-A07

High Pressure Control

Part #RXAB-A07

Liquid Line Solenoid Valve

Part #200RD3T3TVLC

Solenoid Coil 24 VAC

Part #61-AMG24V

Solenoid Coil 120/240 VAC

Part #61-AMG120/240V

Classic Top Cap with Label

Part #91-101123-21

Decorative Top Cap

Part #Not specified

Troubleshooting

Unit making noise

Cause: Loose fasteners, vibration from compressor, or fan issues

Solution: Check and tighten all fasteners; inspect compressor mounting; verify fan operation

May require a professional

Reduced cooling capacity

Cause: Dirty coils, insufficient refrigerant charge, or airflow restriction

Solution: Clean outdoor coil; check for refrigerant leaks; verify adequate clearances around unit

May require a professional

Compressor not starting

Cause: Electrical connection issue, low voltage, or compressor failure

Solution: Verify proper electrical connections; check voltage at unit; inspect contactor and capacitor

May require a professional

High discharge temperature

Cause: Low refrigerant charge, dirty condenser coil, or restricted airflow

Solution: Check refrigerant level; clean coil; verify outdoor fan operation and clear blockages

May require a professional

Outdoor fan not running

Cause: Capacitor failure, motor failure, or electrical issue

Solution: Check capacitor voltage; inspect fan motor; verify electrical connections to fan

Reset Procedures

High/Low Pressure Switch Reset

Turn off power to the unit
Wait 5 minutes
Restore power to the unit
Unit should reset automatically when problem is cleared

Safety Warnings

Refrigerant R-410A is a high-pressure fluid. Do not attempt to service refrigerant components without proper EPA certification and recovery equipment.

Call a professional

Electrical shock hazard. Do not attempt electrical repairs. All electrical work must be performed by qualified technicians. Always disconnect power before servicing.

Call a professional

Unit contains moving parts including high-speed fan. Keep hands, loose clothing, and hair away from rotating components.

Call a professional

Do not apply capillary tube indoor coils to these units. Only use coils matched to this condenser for proper system operation.

Unit must be level in all horizontal planes for proper operation and oil return to compressor.

Ensure adequate ventilation around outdoor unit to prevent re-circulation of discharge air, especially when installing multiple units in enclosed areas.

Use only copper wire for electrical connections. Aluminum and clad aluminum connectors are not acceptable for this unit.

Factory-supplied filter drier must be installed. Do not operate system without proper filtration.

Maximum outdoor operating air temperature is 125°F. Do not operate unit in hotter ambient conditions.

Minimum outdoor operation air temperature for cooling mode without low-ambient accessory is 55°F.

Data sourced from the Rheem owner's manual.

View the full official manual

This guide is provided for informational purposes only. Always consult your official owner's manual before performing maintenance. HomeBase is not responsible for any damage resulting from the use of this information.

Track this appliance free in HomeBase

Related Guides

Rheem RTEX-18

Water Heater

Rheem RTEX-24

Water Heater

Rheem XE50T10HD50U0

Water Heater

Never forget this task again

Track it free with HomeBase — automatic reminders, completion history, and cost tracking for all your home maintenance.

Start Tracking Free